Subaru Legacy 2003 Service Manual page 3406

OIL PUMP
POWER ASSISTED SYSTEM (POWER STEERING)
12) With knock pin positions aligned, install rear
cover.
Tightening torque:
27.5 N·m (2.8 kgf-m, 20.3 ft-lb)
CAUTION:
Loosely tighten bolts in the sequence (A), (B),
(C), and (D) shown in figure. Then, tighten in the
same sequence.
( A )
( C )
( D )
( B )
PS-00241
13) When reassembly procedures have been com-
pleted, turn shaft by hand to ensure it turns smooth-
ly. If it binds or other unusual conditions are
evident, disassemble again and check for foreign
matter trapped on sliding surfaces and improper in-
stallation. Eliminate the cause of trouble.
14) Check followings by referring to "CHECK" arti-
cle.
• Excessive play in pulley shaft
• Ditch deflection of pulley
• Resistance to rotation of pulley
• Measurement of generated oil pressure
PS-85