Subaru Legacy 2003 Service Manual page 3351

POWER ASSISTED SYSTEM (POWER STEERING)
C: DISASSEMBLY
Remove the two screws securing upper steering
column covers, and the two screws securing com-
bination switch, then remove related parts.
D: ASSEMBLY
1) Insert combination switch to upper column shaft,
and install upper column cover. Then route ignition
key harness and combination switch harness be-
tween column cover mounting bosses.
Tightening torque:
1.2 N·m (0.12 kgf-m, 0.9 ft-lb)
CAUTION:
Don't overtorque screw.
E: INSPECTION
1. BASIC INSPECTION
Measure overall length of steering column and if it
is out of standard value, replace it.
Standard value:
Overall length (L)
Except OUTBACK model: 849
+0.059
(33.425 /
-0.020
OUTBACK model: 817
+0.059
/ in)
-0.020
L
2. AIRBAG MODEL INSPECTION
WARNING:
For airbag model inspection procedures, refer
to "Airbag System". <Ref. to AB-12, INSPEC-
TION, Driver's Airbag Module.>
TILT STEERING COLUMN
+1.5
/ mm
-0.5
in)
+1.5
/ mm (32.197
-0.5
PS-00204
PS-30