HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
11.Control Unit
A: REMOVAL
1. AUTO A/C
1) Disconnect ground cable from battery.
2) Remove front cover (A).
3) Loosen 2 screws (B) to remove center panel (C).
( C )
( B )
( A )
(A) Hook pawl
4) Loosen screws to pull control unit slightly out of
center console.
5) Disconnect connector from antenna cable to re-
move control unit.
2. MANUAL A/C
1) Disconnect ground cable from battery.
2) Remove front cover (A).
3) Loosen 2 screws (B) to remove center panel (C).
( C )
( B )
( A )
(A) Hook pawl
CONTROL UNIT
:
( 1 )
AC-00285
AC-00286
:
( 1 )
AC-00285
AC-34
4) Set temperature control switch to "FULL HOT",
and disconnect temperature control cable from
heater unit.
5) Loosen screws to pull control unit slightly out of
center console.
6) Disconnect connector from antenna cable to re-
move control unit.
B: INSTALLATION
1. AUTO A/C
Install in the reverse order of removal.
2. MANUAL A/C
1) Install in the reverse order of removal.
2) Before installation, set temperature control
switch to "FULL HOT".
AC-00287