Subaru Legacy 2003 Service Manual page 3356

13) Using a sharp pointed pliers, rotate the rack
stopper in the direction of the arrow until the end of
the circlip comes out of the stopper. Rotate the cir-
clip in the opposite direction and pull it out.
14) Pull rack assembly from cylinder side, and
draw out rack bushing and rack stopper together
with rack assembly.
CAUTION:
Be careful not to contact rack to inner wall of
cylinder when drawing out. Any scratch on cyl-
inder inner wall will cause oil leakage.
( 2 )
( 3 )
(1) Rack bushing
(2) Rack ASSY
(3) Rack stopper
15) Remove rack bushing and rack stopper from
rack assembly.
CAUTION:
Do not reuse removed rack bushing and circlip.
STEERING GEARBOX [LHD MODEL]
PS-00121
( 1 )
PS-00132
POWER ASSISTED SYSTEM (POWER STEERING)
16) Insert ST from pinion housing side and remove
oil seal using a press.
ST 34199AE050 OIL SEAL REMOVER
(1) Press
(2) Oil seal
NOTE:
Discard removed oil seal.
2. CONTROL VALVE ASSEMBLY
NOTE:
Parts requiring replacement are described in the
smallest unit of spare parts including damaged
parts and spare parts damaged. In actual disas-
sembly work, accidental damage as well as inevita-
ble damage to some related parts must be taken
into account, and spare parts for them must also be
prepared. However, it is essential to pinpoint the
cause of trouble, and limit the number of replace-
ment parts as much as possible.
1) Using ST, loosen lock nut.
ST 926230000
PS-35
( 1 )
ST
( 2 )
PS-00138
SPANNER
ST
PS-00089