Subaru Legacy 2003 Service Manual page 3391

POWER ASSISTED SYSTEM (POWER STEERING)
7. Pipe Assembly
A: REMOVAL
1) Set the vehicle on the lift.
2) Disconnect battery ground cable.
3) Lift vehicle and remove jack-up plate.
(1) Jack-up plate
4) Remove one pipe joint at the center of gearbox,
and connect vinyl hose to pipe and joint. Discharge
fluid by turning steering wheel fully clockwise and
counterclockwise. Discharge fluid similarly from the
other pipe.
CAUTION:
Improper removal and installation of parts often
causes fluid leak trouble. To prevent this, clean
the surrounding portions before disassembly
and reassembly, and pay special attention to
keep dirt and other foreign matter from mating
surfaces.
LHD model
( 2 )
( 1 )
(1) Pipe A
(2) Pipe B
PIPE ASSEMBLY
RHD model
( 1 )
5) Remove clamp E from pipes.
PS-00044
LHD model
PS-00026
PS-70
( 1 )
( 2 )
(1) Pipe A
(2) Pipe B
( 1 )
( 3 )
( 5 )
(1) Return hose
(2) Pressure hose
(3) Clamp E
(4) Pipe C
(5) Pipe D
PS-00333
( 2 )
( 4 )
PS-00176