Subaru Legacy 2003 Service Manual page 3353

POWER ASSISTED SYSTEM (POWER STEERING)
10) Remove clamp bolts securing gearbox to
crossmember, and remove gearbox.
(1) Clamp
B: INSTALLATION
1) Insert gearbox into crossmember, being careful
not to damage gearbox boot.
2) Tighten gearbox to crossmember bracket via
clamp with bolt to the specified torque.
Tightening torque:
59 N·m (6.0 kgf-m, 43 ft-lb)
(1) Clamp
STEERING GEARBOX [LHD MODEL]
( 1 )
PS-00028
( 1 )
PS-00028
PS-32
3) Connect pipes C and D to pipe of gearbox.
NOTE:
Connect lower pipe C first, and upper pipe D sec-
ond.
CAUTION:
Be careful not to damage these pipes.
( 1 )
(1) Pipe C
(2) Pipe D
4) Install universal joint. <Ref. to PS-25, INSTAL-
LATION, Universal Joint.>
5) Connect tie-rod end and knuckle arm, and tight-
en with castle nut. Fit cotter pin into the nut and
bend the pin to lock.
Castle nut tightening torque:
Tighten to 27.0 N·m (2.75 kgf-m, 19.9 ft-lb),
and tighten further within 60 ° ° ° ° until cotter
pin hole is aligned with a slot in the nut.
CAUTION:
When connecting, do not hit cap at the bottom
of tie-rod end with hammer.
(1) Castle nut
(2) Tie-rod end
(3) Knuckle arm
6) Install front stabilizer to vehicle. <Ref. to FS-21,
INSTALLATION, Front Stabilizer.>
( 2 )
PS-00205
( 1 )
( 2 )
( 3 )
PS-00043