Subaru Legacy 2003 Service Manual page 3384

22) Tighten the adjusting screw to specified torque.
Tightening torque:
First step; 7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
Second step; Back off 25°.
23) Install the lock nut. While holding the adjusting
screw with a wrench, tighten lock nut using ST.
ST 926230000 SPANNER
Tightening torque (Lock nut):
39 N·m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening lock nut.
24) Extend the rack approx. 40 mm (1.57 in) be-
yond side of steering body.
25) Install the tie-rod and a new lock washer into
rack.
Tightening torque:
78 N·m (8.0 kgf-m, 57.9 ft-lb)
(1)
(1) Tie-rod
(2) Approx. 40 mm (1.57 in)
STEERING GEARBOX [RHD MODEL]
(2)
PS-00091
PS-63
POWER ASSISTED SYSTEM (POWER STEERING)
26) Bend the lock washer.
CAUTION:
Be careful not to scratch the rack when bending
lock washer.
(1) Lock washer
27) Apply a coat of grease to the tie-rod groove,
and then install the boot to housing.
NOTE:
Make sure that the boot is installed without unusual
inflation or deflation.
( 1 )
PS-00093
PS-00194