Subaru Legacy 2003 Service Manual page 3381

POWER ASSISTED SYSTEM (POWER STEERING)
8) Pass ST2 and pipe through rack and press outer
side oil seal until ST1 is in contact with ST2.
ST1 34199AE000 GUIDE (Oil seal)
ST2 34199AE010 INSTALLER (Oil seal)
ST1
(1) Pipe
(2) Outer side oil seal
9) Install holder from cylinder side of steering body.
Tightening torque:
64 ± ± ± ± 5 N·m (6.5 ± ± ± ± 0.5 kgf-m, 47.0 ± ± ± ± 3.6 ft-lb)
STEERING GEARBOX [RHD MODEL]
( 1 )
ST2
( 2 )
PS-00317
PS-00300
PS-60
10) Attach ST to rack cylinder. Using a press, in-
stall back-up ring and oil seal.
NOTE:
Press ST until its groove is aligned with end of hold-
er.
ST 34099FA030 INSTALLER & REMOVER
( 2 )
(1) Installer guide
(2) Holder
(3) Rack piston
(4) Oil seal
(5) Back-up ring
ST
( 1 )
( 3 )
( 4 )
( 5 )
PS-00318