Subaru Legacy 2003 Service Manual page 3470

22.Air Vent Grille
A: REMOVAL
1. AIR VENT GRILLE DRIVER SIDE
1) Disconnect ground cable from battery.
2) Set tilt steering to the lowest position.
3) Disconnect each electrical connector to remove
front cover (A) and switch panel (B).
4) Loosen screw (C) to remove center panel (D).
5) Remove meter visor (E).
( E )
( B )
( C )
( A )
(1) Hook pawl
6) Loosen screws to remove grille.
AIR VENT GRILLE
( D )
: ( 1 )
AC-00338
AC-00339
AC-49
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
2. AIR VENT GRILLE PASSENGER SIDE
1) Remove grille using sharp-edged screwdriver.
NOTE:
Wrap screwdriver with vinyl tape to prevent dam-
age to interior parts.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
The direction and amount of air should be adjusted
smoothly.
The adjustment should be kept in each position.
AC-00340