Subaru Legacy 2003 Service Manual page 3367

Hide thumbs Also See for Legacy 2003:
Table of Contents

Advertisement

POWER ASSISTED SYSTEM (POWER STEERING)
E: INSPECTION
1. BASIC INSPECTION
1) Clean all disassembled parts, and check for wear, damage, or any other faults, then repair or replace as
necessary.
2) When disassembling, check inside of gearbox for water. If any water is found, carefully check boot for
damage, input shaft dust seal, adjusting screw and boot clips for poor sealing. If faulty, replace with new
parts.
No.
Parts
1
Input shaft
2
Dust seal
3
Rack and pinion
4
Gearbox unit
5
Boot
6
Tie-rod
7
Tie-rod end
Adjusting screw
8
spring
9
Boot clip
10
Sleeve
11
Pipes
STEERING GEARBOX [LHD MODEL]
Inspection
(1) Bend of input shaft
(2) Damage on serration
(1) Crack or damage
(2) Wear
Poor mating of rack with pinion
(1) Bend of rack shaft
(2) Bend of cylinder portion
(3) Crack or damage on cast iron
portion
(4) Wear or damage on rack bush
(5) Wear on input shaft bearing
Crack, damage or deterioration
(1) Looseness of ball joint
(2) Bend of tie-rod
Damage or deterioration on dust
seal
Deterioration
Deterioration
Damage
(1) Damage to flared surface
(2) Damage to flare nut
(3) Damage to pipe
PS-46
Corrective action
If bend or damage is excessive, replace entire gearbox.
If outer wall slips, lip is worn out or damage is found,
replace it with new one.
(1) Adjust backlash properly.
By measuring turning torque of gearbox and sliding resis-
tance of rack, check if rack and pinion engage uniformly
and smoothly with each other. (Refer to "Service limit".)
(2) Keeping rack pulled out all the way so that all teeth
emerge, check teeth for damage.
Even if abnormality is found in either (1) or (2), replace
entire gearbox.
Replace gearbox with new one.
If free play of rack shaft in radial direction is out of the
specified range, replace gearbox with new one. (Refer to
"Service limit".)
If free plays of input shaft in radial and axial directions are
out of the specified ranges, replace gearbox with new
one. (Refer to "Service limit".)
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.

Advertisement

Table of Contents
loading

Table of Contents