Subaru Legacy 2003 Service Manual page 3355

POWER ASSISTED SYSTEM (POWER STEERING)
6) Extend rack approximately 40 mm (1.57 in) out.
Unlock lock wire at lock washer on each side of tie-
rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch rack surface as oil
leaks may result.
( 1 )
(1) Standard screwdriver
(2) Lock washer
7) Using ST, loosen lock nut.
ST 926230000 SPANNER
8) Tighten adjusting screw until it no longer tight-
ens.
9) Using a wrench [32 mm (1.26 in) width across
flats] or adjustable wrench, remove tie-rod.
CAUTION:
• Check ball joint for free play, and tie-rod for
bends. Replace if necessary.
STEERING GEARBOX [LHD MODEL]
40 mm (1.57 in)
( 2 )
PS-00207
ST
PS-00089
PS-00109
• Check dust seals used with tie-rod end ball
joint for damage or deterioration. Replace if
necessary.
10) Loosen adjusting screw and remove spring and
sleeve.
CAUTION:
Replace spring and/or sleeve if damaged.
11) Remove two bolts securing valve assembly.
12) Carefully draw out input shaft and remove
valve assembly.
PS-34
PS-00110
PS-00109
PS-00116
PS-00117