Check Harness And Connector (Shift Position L Switch − Body Ground) - Toyota Tundra 2005 Service - Repair - Maintenance

DI−1106
INSPECTION PROCEDURE
1 Check harness and connector (shift position L switch − body ground).
Wire Harness Side:
(Connector Front View):
I25
OK
2 Inspect center cluster integration panel (shift position L switch).
I25
E
OK
DIAGNOSTICS
PREPARATION:
Remove the center cluster integration panel assembly (shift
position L switch).
CHECK:
Measure the resistance according to the value(s) in the table
below.
OK:
D14179
NG
CHECK:
Measure the resistance according to the value(s) in the table
below.
OK:
Switch Condition
Shift position L switch
pressed and held
Shift position L switch
released
I24
LMS
NG
D13886
− AUTOMATIC TRANSMISSION (A750E for 1GR−FE)
Tester Connection
10 − Body ground
Repair or replace the harness or connector
(See page IN−30).
Tester Connection
I24 − 17 (LMS) −
I25 − 10 (E)
center cluster integration panel
Replace
(shift position L switch).
Specified Condition
Below 1 Ω
Specified Condition
Below 1 Ω
10 kΩ or higher