Primary Authentication - H3C S9500 Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S9500 Series Routing Switches
Description
Use the primary accounting command to configure a primary TACACS accounting
server.
Use the undo primary accounting command to delete the configured primary
TACACS accounting server.
By default, the IP address of the TACACS accounting server is all zeros.
You are not allowed to assign the same IP address to both primary and secondary
accounting servers.
If you repeatedly use this command, the latest configuration overwrites the previous
one.
You can remove a TACACS scheme accounting server only when no Active TCP
connection used to send accounting packets is now using the server, and the removal
impacts only packets forwarded afterwards.
Examples
# Configure a primary accounting server.
[H3C] hwtacacs scheme test1
[H3C-hwtacacs-test1] primary accounting 10.163.155.12 49

1.3.10 primary authentication

Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
HWTACACS view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
port-number: Port number of the server, which is in the range 1 to 65535 and defaults to
49.
Description
Use the primary authentication command to configure a primary TACACS
authentication server.
Use the undo primary authentication command to delete the configured
authentication server.
By default, the IP address of the TACACS authentication server is all zeros.
Chapter 1 AAA, RADIUS, and HWTACACS
Protocol Configuration Commands
1-61