H3C S9500 Series Command Manual page 1750

Command Manual – System Maintenance and Debugging
H3C S9500 Series Routing Switches
Description
Use the display fiber-module command to display the information of the optical
modules connected with all the optical interfaces in position on the current shelf,
including module information, optical module type, connector type, vendor name,
manufacturer part number, single mode or multi-mode, wave length, and transmission
distance.
Use the display fiber-module [ interface-type interface-number | interface-name ]
command to display optical module information of the specified port.
Note:
If the command level that a login user can access is the visit level, the user cannot use
this command. For related information, refer to the user privilege level command.
Examples
# Display the optical module information of all optical interfaces in position on the
current shelf.
<H3C> display fiber-module
GigabitEthernet4/1/1:
Card info: 10G-XFP
Fiber connect: LC
VendorName: JDS Uniphase
PartNumber: 64P0215
SerialNumber: W44060540031
Mode: SingleMode
WaveLength: 1310nm
Length for 9um: 10km
Digital diagnostic monitoring: supported
TX power:
RX power:
Table 1-3 display fiber-module command output description
Card info
Fiber connect
VendorName
PartNumber
Mode
-1.5329 dbm, Alarm: none
-27.9578 dbm, Alarm: none
Field
Card information
Fiber connector type
Vendor name
Manufacturer part number
Single mode or multi-mode
1-8
Chapter 1 System Maintenance and
Debugging Commands
Description