H3C S9500 Series Command Manual page 1761

Command Manual – System Maintenance and Debugging
H3C S9500 Series Routing Switches
5 ccn-nerif22.Berkeley.EDU (128.32.168.22) 20 ms 39 ms 39 ms
6 128.32.197.4 (128.32.197.4) 59 ms 119 ms 39 ms
7 131.119.2.5 (131.119.2.5) 59 ms 59 ms 39 ms
8 129.140.70.13 (129.140.70.13) 80 ms 79 ms 99 ms
9 129.140.71.6 (129.140.71.6) 139 ms 139 ms 159 ms
10 129.140.81.7 (129.140.81.7) 199 ms 180 ms 300 ms
11 129.140.72.17 (129.140.72.17) 300 ms 239 ms 239 ms
12 * * *
13 128.121.54.72 (128.121.54.72) 259 ms 499 ms 279 ms
14 * * *
15 * * *
16 * * *
17 * * *
18 ALLSPICE.LCS.MIT.EDU (18.26.0.115) 339 ms 279 ms 279 ms
1.4.4 tracemac enable
Syntax
tracemac enable
undo tracemac enable
View
System view
Parameters
None
Description
Use the tracemac enable command to enable the TraceMac&Ping Mac function of
the system.
Use the undo tracemac enable command to disable the TraceMac&Ping Mac
function.
Note:
The tracemac&pingmac functions cannot go without the support of NDP, and will not
work if NDP and tracemac are disabled. By default, NDP is disabled.
By default, the TraceMac and Ping Mac functions are disabled on the switch.
Related commands: tracemac.
Chapter 1 System Maintenance and
1-19
Debugging Commands