H3C S9500 Series Command Manual page 1734

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
Description
Use the set vdsllink command to set the VDSL link rate of the port of the switch.
Examples
# Set the VDSL link uplink rate and downlink rate of the port 1 of the switch with the
position parameter of "3/1/3-/" to 2 and 2.
[H3C-lanswitch3/1/3-/] set vdsllink 1 uprate 2 downrate 2
Waiting.....
Config VDSL link successfully!
Note:
This command is only applicable to configuration of S3026 switch on the NMS.
1.3.39 set vlanid
Syntax
set vlanid vlanid port-list
undo set vlanid vlanlist
View
lanswitch view
Parameters
vlanid: VLAN ID.
port-list: List of ports.
vlanlist: List of VLAN IDs.
Description
Use the set vlanid command to set the VLAN attribute for the switch and add the
specified ports to a specified VLAN.
Use the undo set vlanid command to remove VLAN configuration.
Examples
# Add to the VLAN 2 the port 1 through 4 of the switch 3/1/3-/.
[H3C-lanswitch3/1/3-/] set vlanid 2 1-4
Waiting.....
Modifying LANSWITCH[3/1/3-/]'s VlanID successfully!
Chapter 1 HGMP V1 Configuration Commands
1-59