H3C S9500 Series Command Manual page 1778

Command Manual – Information Center
H3C S9500 Series Routing Switches
1.1.11 info-center loghost
Syntax
info-center loghost { source interface-type interface-number | host-ip-addr [ channel
{ channel-number | channel-name } | facility local-number | language { chinese |
english } ]*}
undo info-center loghost host-ip-addr
View
System view
Parameters
host-ip-addr: IP address of info-center loghost.
channel: Configures information channel of the info-center loghost.
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specifies the channel name. The name can be channel7, channel8,
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfile.
Source: Source address of the packet sent to the loghost.
interface-type interface-number: Type and number of interface sending log file.
facility: Configures the recording tool of info-center loghost.
local-number: Record tool of info-center loghost, ranging from local0 to local7.
language: Sets the logging language.
chinese, english: Language used in log file.
Description
Use the info-center loghost command to configure the system to output information to
the log host.
Use the undo info-center loghost command to cancel output to info-center loghost.
By default, Ethernet switches do not output information to info-center loghost.
This command takes effect only after the system logging is enabled.
Related commands: info-center enable, display info-center.
Examples
# Configure to send log information to the UNIX workstation at 202.38.160.1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center loghost 202.38.160.1
1-13
Chapter 1 Information Center