H3C S9500 Series Command Manual page 1727

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
Parameters
ip-address: the IP address of the gateway.
Description
Use the set gatewayip command to set the IP address of the gateway of the switch.
Use the undo set gatewayip command to undo the set.
Examples
# Set the IP address of the gateway of the switch with the position parameter of "3/1/3-/"
as 1.1.1.1.
[H3C-lanswitch3/1/3-/]set gatewayip 1.1.1.1
Waiting.....
Add gateway IP address of LANSWITCH[3/1/3-/] successfully!
# Cancel the IP address 1.1.1.1 of the gateway of the switch with the position
parameter of "3/1/3-/".
[H3C-lanswitch3/1/3-/]undo set gatewayip 1.1.1.1
Waiting.....
Cancel gateway IP address of LANSWITCH[3/1/3-/] successfully!
Note:
This command is only applicable to the configuration of S2008, S2016 and S3026
switches on the NMS.
1.3.29 set link-aggregation
Syntax
set link-aggregation port-list { sa | dasa } groupid
undo set link-aggregation
View
lanswitch view
Parameters
port-list: List of ports to be aggregated.
sa: Specifies to enable port aggregating only for source addresses.
dasa: Specifies to enable port aggregating for both source and destination addresses.
groupid: Link-aggregation number. This argument can only be 1 at present.
Chapter 1 HGMP V1 Configuration Commands
1-52