Download Print this page
H3C S9500 Series Operation Manual
H3C S9500 Series Operation Manual

H3C S9500 Series Operation Manual

Routing switches, pos interface
Hide thumbs Also See for S9500 Series:

Advertisement

Quick Links

Operation Manual – POS Interface
H3C S9500 Series Routing Switches
Chapter 1 POS Interface Configuration....................................................................................... 1-1
1.1 Overview ............................................................................................................................ 1-1
1.1.1 SONET/SDH ........................................................................................................... 1-1
1.1.2 POS......................................................................................................................... 1-1
1.2 Configuring a POS Interface.............................................................................................. 1-1
1.3 Displaying and Maintaining POS Interfaces ...................................................................... 1-3
1.4 POS Interface Configuration Example............................................................................... 1-3
1.4.1 Network Requirements............................................................................................ 1-3
1.4.2 Network Diagram..................................................................................................... 1-4
1.4.3 Configuration procedure.......................................................................................... 1-4
1.5 Troubleshooting POS Interfaces........................................................................................ 1-4
Table of Contents
i
Table of Contents

Advertisement

loading
Need help?

Need help?

Do you have a question about the S9500 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for H3C S9500 Series

  • Page 1 Operation Manual – POS Interface H3C S9500 Series Routing Switches Table of Contents Table of Contents Chapter 1 POS Interface Configuration..................1-1 1.1 Overview ..........................1-1 1.1.1 SONET/SDH ......................1-1 1.1.2 POS......................... 1-1 1.2 Configuring a POS Interface....................1-1 1.3 Displaying and Maintaining POS Interfaces ..............1-3 1.4 POS Interface Configuration Example................
  • Page 2 Operation Manual – POS Interface H3C S9500 Series Routing Switches Chapter 1 POS Interface Configuration Chapter 1 POS Interface Configuration When configuring a POS interface, go to these sections for information you are interested in: Overview Configuring a POS Interface...
  • Page 3 Operation Manual – POS Interface H3C S9500 Series Routing Switches Chapter 1 POS Interface Configuration To do... Use the command... Remarks Enter system view system-view –– interface pos Enter POS interface view Required interface-number Optional Set the clock mode clock { master | slave } The default is slave.
  • Page 4: Network Requirements

    Note: At present, POS interfaces on S9500 series routing switches only support PPP on data link layer. Currently, POS interfaces on S9500 series routing switches do not support IPv6 multicast. Therefore, the commands related to IPv6 multicast are not supported in POS interface view.
  • Page 5: Network Diagram

    Operation Manual – POS Interface H3C S9500 Series Routing Switches Chapter 1 POS Interface Configuration 1.4.2 Network Diagram POS 1/1/1 POS4 /1/1 10 .110 .1 .10 /24 10.110.1.11/24 Switch A Switch B Figure 1-1 Network diagram for connecting two POS interfaces through fiber 1.4.3 Configuration procedure...
  • Page 6 Operation Manual – POS Interface H3C S9500 Series Routing Switches Chapter 1 POS Interface Configuration Solution: Check that the transmitting and receiving fibers-optic are correctly connected to the POS interface. If you connect the two ends of a fiber-optic to the transmitting end and the receiving end of the same POS interface, you can see the message “loopback detected”...