H3C S9500 Series Command Manual page 1840

Command Manual – OAP Module
H3C S9500 Series Routing Switches
Chapter 1 OAP Module Configuration Commands
1.1 OAP Module Configuration Commands
1.1.1 oap connect slot
Syntax
oap connect slot slot-number
View
User view
Parameters
slot-number: Number of the slot where an OAP module resides.
Description
Use the oap connect slot command to redirect from the device to the OAP module.
You can press Ctrl+k to return from the operating system on the OAP module to the
command line interface on the device.
Examples
# Redirect from the command line interface on the device to the operating system of the
OAP module in slot 3.
<Sysname> oap connect slot 3
Connected to OAP!
# After viewing the above information, press Enter to switch to the operating system of
the OAP module.
<H3C>
# Press Ctrl+K to return from the operating system on the OAP module to the
command line interface on the device.
<Sysname>
1.1.2 oap management-ip
Syntax
oap management-ip ip-address slot slot-number
undo oap management-ip slot slot-number
Chapter 1 OAP Module Configuration Commands
1-1