H3C S9500 Series Command Manual page 1748

Command Manual – System Maintenance and Debugging
H3C S9500 Series Routing Switches
1.2.2 display debugging
Syntax
display debugging [ interface interface-type interface-number ] [ module-name ]
View
Any view
Parameters
interface-type: Interface type supported by the switch, including Ethernet,
GigabitEthernet, AUX, and VLAN-interface.
interface-number: Interface number.
module-name: Module name.
Description
Use the display debugging command to display debugging that has been enabled.
You can execute the display debugging to view the specific debugging that has been
enabled. If the command is executed without any parameter specified, the system will
display all debugging that has been enabled.
Related commands: debugging.
Examples
# Display all debugging that has been enabled.
<H3C> display debugging
Multicast packet forwarding debugging switch is on
1.2.3 display device manuinfo
Syntax
display device manuinfo [ slot slot-number ]
View
Any view
Parameters
slot-number: Number of the slot where a card is located.
Description
Use the display device manuinfo command to display the manufacturing information
of a card. If no slot number is specified, the command displays the manufacturing
information of all cards.
Chapter 1 System Maintenance and
1-6
Debugging Commands