H3C S9500 Series Command Manual page 1728

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
Description
Use the set link-aggregation command to aggregate multiple ports of a switch to an
aggregation port, through which a larger capacity can be obtained.
Use the undo set link-aggregation command to remove the configuration.
An S2008B series switch does not support link aggregation; an S2016B series switch
can only has its Ethernet0/15 and Ethernet0/16 port aggregated in the dasa mode; an
S2026B series switch can only has its Ethernet0/23 and Ethernet0/24 port aggregated
in the dasa mode. You can use the query link-aggregation command to verify the set
link-aggregation command.
Related commands: query link-aggregation.
Examples
# Set the ports 15 and 16 of the switch with a position parameter of 3/1/3-/ as an
aggregation port.
[H3C-lanswitch3/1/3-/] set link-aggregation 15-16 sa 1
1.3.30 set loop-test
Syntax
set loop-test { internal | external } port-list
View
lanswitch view
Parameters
internal | external: Specifies the way to perform loopback test. The internal and
external keywords stand for internal loopback test and external loopback test
respectively.
port-list: List of ports the specified loopback test method applies to.
Description
Use the set loop-test command to perform specified type of loopback test on specified
ports.
Examples
# Specify to perform internal loopback test on the port of switch 3/1/3-/.
[H3C-lanswitch3/1/3-/] set loop-test internal 1
Chapter 1 HGMP V1 Configuration Commands
1-53