Display Qos-Vlan Traffic-Priority - H3C S9500 Series Command Manual

Command Manual – QoS
H3C S9500 Series Routing Switches
Peak Information Rate: 0 Kbps
Exceed action: drop
Outbound:
There is no configuration.

5.1.3 display qos-vlan traffic-priority

Syntax
display qos-vlan [ vlan-id ] traffic-priority
View
Any view
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094.
Description
Use the display qos-vlan traffic-priority command to display the priority marking
configuration on VLAN, including the ACL used to filter the traffic that priority marking is
performed on, the type and values of priority marking.
Related commands: traffic-priority.
Examples
# Display the priority marking configuration on VLANs.
<H3C> display qos-vlan traffic-priority
Vlan 1 traffic-priority
Inbound:
There is no configuration.
Outbound:
There is no configuration
Vlan 2 traffic-priority
Inbound:
Matches: Acl 2000 rule 1 running (Action-type: Vlan-acl, Destination slot:
3)
Priority action: remark-policed-service, untrusted, dscp: 13, cos: 6,
local-precedence: 6, drop-priority: 1
Outbound:
There is no configuration.
Chapter 5 VLAN-ACL Configuration Commands
5-4