H3C S9500 Series Command Manual page 1801

Command Manual – PoE
H3C S9500 Series Routing Switches
Description
Use the poe mode command to configure the PoE mode on the current port.
Use the undo poe mode command to restore the default PoE mode on current port.
By default, the port adopts signal lines to supply power.
Caution:
H3C S9500 series routing switches currently do not support the spare mode. If a PD
only supports the spare mode, a conversion is needed.
Examples
# Configure the PoE mode on current port to signal.
[H3C-GigabitEthernet3/1/1] poe mode signal
1.1.11 poe power-management
Syntax
poe power-management { auto | manual } slot slot-num
View
System view
Parameters
slot-num: Number of the slot where the board resides.
auto: The switch automatically manages the PoE mode on a board.
manual: You need to manually manage the PoE mode on a board on the switch.
Description
Use the poe power-management command to configure the PoE power management
mode for a board on the switch.
By default, you need to manually manage PoE on the board on the switch.
Before the power supply is almost fully loaded, the system powers all ports. Working
together with the command for configuring PoE priority on a port, this command takes
effect when the external power supply by the switch is almost fully loaded.
The following section describes PoE in auto mode and in manual mode:
Chapter 1 PoE Configuration Commands
1-9