H3C S9500 Series Command Manual page 1799

Command Manual – PoE
H3C S9500 Series Routing Switches
By default, the board does not detect the compatibility of the PD connected to it.
Caution:
Detecting an incompatible device slows down the detection and decreases system
performance; therefore, you are not recommended to enable compatibility detection if
the device connected is 802.3af-compliant.
Examples
# Enable the board in slot 2 to detect the compatibility of the PD connected to it.
[H3C] poe legacy enable slot 2
# Disable the detection of the compatibility of the PD connected to the board in slot 2.
[H3C] undo poe legacy enable slot 2
1.1.8 poe max-power
Syntax
poe max-power max-power
undo poe max-power
View
Ethernet port view
Parameters
max-power: Maximum power distributed to the port, ranging from 3,000 mW to 15,400
mW.
Description
Use the poe max-power command to set the maximum PoE power on the current port.
Use the undo poe max-power command to restore the default PoE power on current
port.
By default, the maximum PoE power on a port is 15,400 mW.
Examples
# Set the maximum PoE power on the current port GigabitEthernet 3/1/1 to 12,000 mW.
[H3C-GigabitEthernet3/1/1] poe max-power 12000
# Restore the default maximum PoE power on the current port GigabitEthernet 3/1/1.
Chapter 1 PoE Configuration Commands
1-7