H3C S9500 Series Command Manual page 1780

Command Manual – Information Center
H3C S9500 Series Routing Switches
Description
Use the info-center monitor channel command to configure the channel to output the
log information to the user terminal.
Use the undo info-center monitor channel command to restore the channel to output
the log information to the user terminal to default value.
By default, Ethernet switches do not output log information to user terminal.
This command takes effect only after system logging is started.
Related commands: info-center enable, display info-center.
Examples
# Configure channel 0 to output log information to user terminal.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center monitor channel 0
1.1.14 info-center snmp channel
Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
View
System view
Parameters
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels. By default, channel 5 is used.
channel-name: Channel name. The name can be channel7, channel8, channel9,
console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfile.
Description
Use the info-center snmp channel command to configure new channel for
transmitting the SNMP information.
Use the undo info-center snmp channel command to restore the default channel for
transmitting the SNMP information.
The default channel for transmitting the SNMP information is channel 5.
Examples
# Configure channel 6 as the SNMP information channel.
1-15
Chapter 1 Information Center