H3C S9500 Series Command Manual page 1737

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
Table 2-1 display ndp command output description
Interface: Ethernet1/1/1
Status: Enabled
Pkts Snd:
Pkts Rvd:
Pkts Err:
Neighbor 1: Aging Time:
177(s)
MAC Address
Host name
Port Name
Software Ver
Device Name
Port Duplex
Product Ver
BootROM Ver
2.1.2 ndp enable
Syntax
In system view:
ndp enable [ interface port-list | all ]
undo ndp enable [ interface port-list | all ]
In Ethernet port view:
ndp enable
undo ndp enable
View
System view, Ethernet port view
Parameters
interface port-list: Specified port list, which can be a list of sequentially-numbered ports,
or a single port, or a combination of the two. It takes the form of { interface-type
interface-number [ to interface-type interface-number ] } &<1-10>, where interface-type
is the interface type, interface-number is the port number in the format of slot
Field
Port number
The NDP of a specific port is enabled.
Number of NDP packets sent on the port
Number of NDP packets received on the port
Number of erroneous NDP packets received on the port
NDP aging time of the neighbor device connected to the
current port
MAC address of the neighbor device
Host name
Port name of the neighbor device
Software version of the neighbor device
Device name of the neighbor device
Simplex/duplex port on the neighbor device
Product version of the neighbor device
Boot ROM version of the neighbor device
Chapter 2 NDP Configuration Commands
Description
2-2