Pim Bsr-Boundary - H3C S9500 Series Command Manual

Command Manual – PIM
H3C S9500 Series Routing Switches
View
System view
Parameters
None
Description
Use the pim command to enter PIM view.
Use the undo pim command to clear the PIM global parameters configured in PIM
view and return back to system view.
This command takes effect only if IP multicast routing is enabled on the device.
Examples
# Enter PIM view.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] multicast routing-enable
[H3C] pim
[H3C-pim]

1.1.14 pim bsr-boundary

Syntax
pim bsr-boundary
undo pim bsr-boundary
View
Interface view
Parameters
None
Description
Use the pim bsr-boundary command to configure an interface to be the PIM domain
border.
Use the undo pim bsr-boundary command to remove the border.
By default, no domain border is set.
You can use this command to set border of bootstrap messages, that is to say,
bootstrap messages cannot pass interfaces that are configured with the pim
Chapter 1 PIM Configuration Commands
1-14