Chapter 3 Wan Qos Configuration Commands; Qos Enable - H3C S9500 Series Command Manual

Command Manual – QoS
H3C S9500 Series Routing Switches

Chapter 3 WAN QoS Configuration Commands

3.1 WAN QoS Configuration Commands

3.1.1 qos enable

Syntax
qos enable
undo qos enable
View
Channelized serial interface view, MP interface view
Parameters
None
Description
Use the qos enable command to enable QoS on the specified WAN interface.
Use the undo qos enable command to disable QoS on the specified WAN interface.
Note:
You can use the display interface command to check whether QoS is enabled on an
interface.
Examples
# Enable QoS on Serial 1/1/1/1:0.
<H3C> system-view
[H3C] interface serial 1/1/1/1:0
[H3C-Serial1/1/1/1:0] qos enable
3.1.2 queue-scheduler wrr
Syntax
queue-scheduler wrr group { queue-id queue-weight } & <1-4>
undo queue-scheduler
Chapter 3 WAN QoS Configuration Commands
3-1