H3C S9500 Series Command Manual page 1820

Command Manual – Clock Module
H3C S9500 Series Routing Switches
The SSM function of the clock module is not engaged in control by default.
Examples
# Enable the SSM function to get engaged in control,
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] clock ssmcontrol on
# Restore the SSM function of the clock module to the default configuration.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] undo clock ssmcontrol
1.1.8 clock stop warm-up
Syntax
clock stop warm-up
View
System view
Parameters
None
Description
Use the clock stop warm-up command to force the clock module to stop warming up
the local oscillator and switch into normal work.
Examples
# Force the clock module to stop warming up the local oscillator and switch into normal
work.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] clock stop warm-up
1.1.9 display clock device
Syntax
display clock device
View
Any view
Chapter 1 Clock Module Commands
1-8