H3C S9500 Series Command Manual page 1726

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
[H3C-lanswitch3/1/3-/] set address agedtime 100
Waiting.....
Config address aged time successfully!
Note:
This command is only applicable to the configuration of S2008B, S2026B and S2016B
switches on the NMS.
1.3.27 set config-flash
Syntax
set config-flash { write | erase }
View
lanswitch view
Parameters
write: Specifies to write the configuration file to the flash memory.
erase: Specifies to remove the configuration file saved in the flash memory.
Description
Use the set config-flash command to save/remove the configuration file in/from the
flash memory.
Examples
# Write the current configuration file to the flash memory.
[H3C-lanswitch3/1/3-/] set config-flash write
1.3.28 set gatewayip
Syntax
set gatewayip ip-address
undo set gatewayip ip-address
View
lanswitch view
Chapter 1 HGMP V1 Configuration Commands
1-51