Send-Trap - H3C S9500 Series Command Manual

Command Manual – NQA
H3C S9500 Series Routing Switches
mode. The destination and the device are directly connected without any layer 3
devices in between.
Use the undo sendpacket passroute command to cancel this assumption.
By default, no such assumption
Note:
If you assume the connection mode as direct connection mode, actually it equals to
set the TTL to 1.
If you assume the connection mode as direct mode, but set the TTL value at the
same time, then the TTL value does not take effect. This value takes effect when
you cancel the configuration on the connection mode.
Examples
# Set that the system assumes the connection mode as direct connection when
sending the ICMP packet.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] nqa-agent enable
[H3C] nqa administrator icmp
[H3C-nqa-administrator-icmp] sendpacket passroute

1.1.15 send-trap

Syntax
send-trap { all | { probefailure | testcomplete | testfailure } * }
undo send-trap { all | { probefailure | testcomplete | testfailure } * }
View
NQA test group view
Parameters
probefailure: Sends the Trap information to the network management system when
the probe fails and the corresponding filter condition is satisfied.
testcomplete: Sends the Trap information to the network management system when
the test is finished.
testfailure: Sends the Trap information to the network management system when the
test fails and the corresponding filter condition is satisfied.
Chapter 1 NQA Configuration Commands
1-13