H3C S9500 Series Command Manual page 1774

Command Manual – Information Center
H3C S9500 Series Routing Switches
Examples
# Rename the channel 0 as execconsole.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center channel 0 name execconsole
1.1.7 info-center console channel
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
Parameters
channel-number: Channel number, in the range 0 to 9, that is, system has ten
channels.
channel-name: Specifies the channel name. The name can be channel7, channel8,
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfile.
Description
Use the info-center console channel command to configure the channel through
which the log information is output to the console.
By default, Ethernet switches do not output log information to the console.
This command takes effect only after system logging is started.
Related commands: info-center enable, display info-center.
Examples
# Configure to output log information to the console through channel 0.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center console channel 0
1.1.8 info-center enable
Syntax
info-center enable
undo info-center enable
1-9
Chapter 1 Information Center