H3C S9500 Series Command Manual page 1785

Command Manual – Information Center
H3C S9500 Series Routing Switches
Channel
Channel8
Channel9
Note:
If you only specify the level for one/two of the three types of information, the level(s) of
the unspecified two/one return(s) to the default. For example, if you only define the
level of the log information, then the levels of the trap and debugging information return
to the defaults.
channel-number: Channel number to be set.
channel-name: Channel name to be set. The name can be channel7, channel8,
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfile.
state: Sets the state of the information.
state: Specifies the state as on or off.
Description
Use the info-center source command to add/delete a record to the information
channel.
Use the undo info-center source command to cancel the contents of the information
channel.
Use this command to configure the information of log/trap/debugging type. For
example, for the filter of IP module log output, you can configure to output the logs at a
level higher than warnings to the log host and output those higher than informational to
the log buffer. You can also configure to output the trap information on the IP module to
a specified trap host, and so on.
The channels for filtering in all the directions are specified by this configuration
command. All the information will be sent to the corresponding directions through the
specified channels. You can configure the channels in the output direction, channel
filter information, filtering and redirecting of all kinds of information.
At present, the system distributes an information channel in each output direction by
default, shown as follows:
Log information
switch
Enable Enable
Enable Enable
1-20
Chapter 1 Information Center
Trap information
switch
Disable
Disable
Debug
information
switch