H3C S9500 Series Command Manual page 1729

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
1.3.31 set manageip
Syntax
set manageip ip-address netmask [ vlan-id ]
undo set mangeip ip-address netmask [ vlan-id ]
View
lanswitch view
Parameters
ip-address: IP address.
netmask: Subnet mask.
vlan-id: VLAN ID.
Description
Use the set manageip command to set the management IP address of the switch.
Use the undo set mangeip command to cancel the setting.
Examples
# Set the management IP address of the switch with the position parameter of "3/1/3-/"
to 1.1.1.1.
[H3C-lanswitch3/1/3-/]set manageip 1.1.1.1 255.255.255.0
Waiting.....
Add management IP address of LANSWITCH[3/1/3-/] successfully!
# Cancel the management IP address 1.1.1.1 of the switch with the position parameter
of "3/1/3-/".
[H3C-lanswitch3/1/3-/]undo set manageip 1.1.1.1 255.255.255.0 1
Waiting.....
Cancel management IP address of LANSWITCH[3/1/3-/] successfully!
Note:
This command is only applicable to the configuration of S2008, S2016 and S3026
switches on the NMS.
Chapter 1 HGMP V1 Configuration Commands
1-54