H3C S9500 Series Command Manual page 1766

Command Manual – Information Center
H3C S9500 Series Routing Switches
Chapter 1 Information Center
1.1 Information Center Configuration Commands
1.1.1 display channel
Syntax
display channel [ channel-number | channel-name ]
View
Any view
Parameters
channel-number: Channel number, in the range 0 to 9, that is, the system has ten
channels.
channel-name: Specifies the channel name. The name can be channel7, channel8,
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfile.
Description
Use the display channel command to view the details about the information channel.
Without parameter, the display channel command shows the configurations of all the
channels.
Examples
# Show details about the information channel 0.
<H3C> display channel 0
channel number:0, channel name:console
MODU_ID
LEVEL
0xffff0000
1.1.2 display info-center
Syntax
display info-center
View
Any view
NAME ENABLE LOG LEVEL
default Y warning Y
ENABLE TRAP LEVEL
debugging
1-1
Chapter 1 Information Center
ENABLE DEBUGGING
Y debugging