H3C S9500 Series Command Manual page 1736

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
Chapter 2 NDP Configuration Commands
2.1 NDP Configuration Commands
2.1.1 display ndp
Syntax
display ndp [ interface port-list ]
View
Any view
Parameters
interface port-list: Specified port list, which can be a list of sequentially-numbered ports,
or a single port, or a combination of the two. It takes the form of { interface-type
interface-number [ to interface-type interface-number ] } &<1-10>, where interface-type
is the port type, interface-number is the port number in the format of slot number/port
number, and to indicates the port range.
Description
Use the display ndp command to display the global NDP configuration, including the
interval at which NDP packets are sent, the aging timer for the NDP information, and
the neighbor information of the specified port. If you do not specify any port number,
neighbor information of all ports will be displayed.
Examples
# Display NDP configuration on Ethernet 1/1/1.
<H3C> display ndp interface Ethernet1/1/1
Interface: Ethernet1/1/1
Status: Enabled, Pkts Snd: 1, Pkts Rvd: 1, Pkts Err: 0
Neighbor 1:
MAC Address : 00e0-fc38-e8b6
Host Name
Port Name
Software Ver: 3.10
Device Name : H3C S9500
Port Duplex : AUTO
Product Ver : S9500-CMW310-r1271
BootROM Ver : 201
Aging Time: 177(s)
: H3C
: Ethernet1/1/1
2-1
Chapter 2 NDP Configuration Commands