Peer Allow-As-Loop - H3C S9500 Series Command Manual

Command Manual – MBGP
H3C S9500 Series Routing Switches
Description
Use the peer advertise-community command to set to send community attributes to a
peer group.
Use the undo peer advertise-community command to remove the configuration.
By default, no community attribute is sent to any peer group.
Examples
# Configure to send community attributes to peer group "test".
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] bgp 100
[H3C-bgp] ipv4-family multicast
[H3C-bgp-af-mul] peer test advertise-community

1.1.23 peer allow-as-loop

Syntax
peer { group-name | peer-address } allow-as-loop [ number ]
undo peer { group-name | peer-address } allow-as-loop
View
IPv4 multicast sub-address family view
Parameters
group-name: Name of the peer group.
peer-address: IP address of the peer.
number: Number of repetitions of local AS IDs, in the range of 1 to 10. By default, the
number of repetitions is 3.
Description
Use the peer allow-as-loop command to specify the number of repetitions of local AS
IDs.
Use the undo peer allow-as-loop command to remove the configuration.
Related commands: display current-configuration, display bgp routing-table peer.
Examples
# Set the number of repetitions of local AS IDs to 2.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] bgp 100
Chapter 1 MBGP Multicast Extension Configuration
1-15
Commands