H3C S9500 Series Command Manual page 1758

Command Manual – System Maintenance and Debugging
H3C S9500 Series Routing Switches
If the network transmits data rather slowly, you can set a bigger timeout.
Related commands: tracert.
Examples
# Check whether the host with an IP address of 202.38.160.244 is reachable.
<H3C> ping 202.38.160.244
ping 202.38.160.244 : 56 data bytes
Reply from 202.38.160.244 : bytes=56 sequence=1 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=2 ttl=255 time = 2ms
Reply from 202.38.160.244 : bytes=56 sequence=3 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=4 ttl=255 time = 3ms
Reply from 202.38.160.244 : bytes=56 sequence=5 ttl=255 time = 2ms
--202.38.160.244 ping statistics--
5 packet transmitted
5 packet received
0% packet loss
round-trip min/avg/max = 1/2/3 ms
1.4.2 pingmac
Syntax
pingmac mac-address vlan vlan-id
View
Any view
Parameters
mac-address: MAC address of the destination host. The format is H-H-H.
vlan-id: VLAN that the destination host belongs to, in the range of 1 to 4094.
Description
Use the pingmac command to check the layer-2 network connection and the
reachability of the host.
Chapter 1 System Maintenance and
1-16
Debugging Commands