H3C S9500 Series Command Manual page 1795

Command Manual – PoE
H3C S9500 Series Routing Switches
View
Any view
Parameters
interface-type interface-number: Port type and port number.
Description
Use the display poe interface power interface-type interface-number command to
display the PoE power information of the specified port on the switch. If you enter the
display poe interface power command without any argument, the PoE power
information about all PoE-capable ports on the switch will be displayed.
Examples
# Display the power information of the port GigabitEthernet 3/1/1.
<H3C> display poe interface power GigabitEthernet3/1/1
Port power
1.1.3 display poe pse
Syntax
display poe pse
View
Any view
Parameters
None
Description
Use the display poe pse command to display the parameters of all the PoE cards in
the switch that serve as a power sourcing equipment (PSE).
Examples
# Display the parameters of all the PoE cards in the switch.
<H3C> display poe pse
PSE Information of board 6:
Power Current Value
Power Remaining Value
Power Max Value
Power Peak Value
Power Average Value
Chapter 1 PoE Configuration Commands
:700 mW
:67 W
: 673 W
:740 W
:1 W
:0 W
1-3