H3C S9500 Series Command Manual page 1753

Command Manual – System Maintenance and Debugging
H3C S9500 Series Routing Switches
<H3C> display version
H3C Comware Platform Software
Comware software, Version 3.10, Feature 1631
Copyright(c) 2004-2007 Hangzhou H3C Technologies Co., Ltd. All rights
reserved.
H3C S9505 uptime is 0 week, 2 days, 4 hours, 19 minutes
LSB1SRP1N6 1:
H3C S9500 with 1 MPC755 Processor
512M
16384K
512K
PCB Version
BootROM Version
CPLD Version
Software Version :
LSB1GT12B0 3:
H3C S9500 LPU with 1 MPC8245 Processor
128M
0K
PCB Version
BootROM Version
1.3 System Debugging Commands
1.3.1 debugging
Syntax
debugging { all | timeout interval | module-name [ debugging-option ] }
undo debugging { all | module-name [ debugging-option ] }
View
User view
Parameters
all: Enables or disables all the debugging.
timeout interval: Specifies the interval (in minutes) during which the debugging all
switch is on. The value ranges from 1 to 1440. With this configuration, all debugging
takes the time at which it is enabled as the start time, and takes effect during the
predefined time. And after that, all debugging is disabled.
uptime is 0 week,2 days,4 hours,19 minutes
bytes SDRAM
bytes Flash Memory
bytes NVRAM Memory
: Ver.B
: 123
: 001
S9500-CMW310-F1631
uptime is 0 week,2 days,4 hours,17 minutes
bytes SDRAM
bytes NVRAM Memory
: REV.0
: 103
Chapter 1 System Maintenance and
1-11
Debugging Commands