H3C S9500 Series Command Manual page 1794

Command Manual – PoE
H3C S9500 Series Routing Switches
Table 1-1 display poe interface command output description
Port power status
Port power mode
Port PD class
Port power priority
Port max power
Port current power
Port average power
Port peak power
Port current
Port voltage
Port remaining
power
Note:
The sampling cycle of the power, current and voltage of ports is 1 second;
The sampling cycle of the peak power and average power of ports is 5 minutes
1.1.2 display poe interface power
Syntax
display poe interface power [ interface-type interface-number ]
Field
PoE status of the port:
1) disabled: PoE is disabled on the port.
2) searching: the port is searching for a PD.
3) delivering: the port is supplying power to the PD.
4) PD disconnected: the port is not connected with a PD.
5) testing: the port is in testing.
6) fault: the port detected an nonstandard or fault PD.
PoE mode of the port:
1) auto: the system automatically selects the PoE mode.
2) signal
3) spare
The class of the power the port supplies to the PD
Port priority:
1) critical (the highest)
2) high
3) low
Maximum power on the port
Present power on the port
Average power on the port
Peak power on the port
Present current on the port
Present voltage on the port
Remaining power on the port
Chapter 1 PoE Configuration Commands
Description
1-2