H3C S9500 Series Command Manual page 1841

Command Manual – OAP Module
H3C S9500 Series Routing Switches
View
System view
Parameters
slot slot-number: Number of the slot where an OAP module resides.
ip-address: Management IP address of the OAP module.
Description
Use the oap management-ip command to configure the management IP address of
an OAP module.
Use the undo oap management-ip command to restore the system default.
By default, the management IP address of an OAP module is not configured.
When you use network management station (NMS) to manage an OAP module, you
must first configure the management IP address of the OAP module.
Caution:
Before configuring the management IP address of the OAP module on the switch
side, you must configure the same IP address on the OAP module side; otherwise,
the NMS cannot access the OAP module through this management IP address.
For operations on the OAP module side, refer to the corresponding document of
OAP module.
Examples
# Configure the management IP address of the OAP module in slot 3 as 1.1.1.1.
<Sysname> System-view
[Sysname] oap management-ip 1.1.1.1 slot 3
1.1.3 oap reboot slot
Syntax
oap reboot slot slot-number
View
User view
Chapter 1 OAP Module Configuration Commands
1-2