H3C S9500 Series Command Manual page 1731

Command Manual – Cluster Management
H3C S9500 Series Routing Switches
vlanid vlan-id-list [ tagged | untagged ]: Specifies a list of VLAN IDs to be assigned to
ports specified by the port-list argument and whether or not these ports are tagged. The
VLAN ID values range from 0 to 4,095, of which value of 0 means no VLAN ID is set for
the corresponding port. As the VLAN IDs specified by the vlan-id-list argument are
one-to-one mapped to the port numbers specified by the port-list argument,, the
number of the ports specified by the port-list argument must be the same as that of the
VLAN IDs specified by the vlan-id-list argument.
Description
Use the set port command to assign VLAN IDs to ports of a switch and specify whether
or not these ports are tagged.
To avoid communication between a management device and the switches connected
to it being unexpectedly terminated, the VLAN ID of an upstream port cannot be set to
2047, which is reserved by the system, and an upstream port cannot be set to be an
untagged port.
Related commands: query port.
Examples
# Configure the port 3 of the switch with a position parameter of 3/1/3-/.
[H3C-lanswitch3/1/3-/] set port 3 vlanid 4 untagged
Waiting....
Operate LANSWITCH[3/1/3-/]'s ports successfully!
1.3.34 set priority
Syntax
set priority { high | low } port-list
View
lanswitch view
Parameters
high | low: Sets the priorities of ports to be high or low.
port-list: List of ports to be set.
Description
Use the set priority command to set the priorities of specifies ports.
Related commands: set qos_weight.
Examples
# Set the port 1 of the switch with a position parameter of 3/1/3-/ to be of high priority.
Chapter 1 HGMP V1 Configuration Commands
1-56