H3C S9500 Series Command Manual page 1776

Command Manual – Information Center
H3C S9500 Series Routing Switches
Description
Use the info-center logbuffer command to configure to output information to the
memory buffer.
Use the undo info-center logbuffer command to cancel the information output to
buffer.
By default, the switch outputs information to the memory buffer whose size is 512, that
is, the memory buffer can hold 512 messages.
This command takes effect only after the system logging is enabled.
Related commands: info-center enable, display info-center.
Examples
# Send log information to buffer and sets the size of buffer to 50.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center logbuffer size 50
1.1.10 info-center logfile
Syntax
info-center logfile [ channel { channel-number | channel-name } | size logfile-size |
directory directory | number logfile-num ]*
info-center logfile [ flush ]
undo info-center logfile [ channel | size | directory | number ]
View
System view
Parameters
channel: Specifies the channel whereby to output information to a log file.
channel-number: Channel number, in the range 0 to 9 (that is, the system has 10
channels).
channel-name: Channel name. The channel name range is: channel7, channel8,
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer, and
logfile.
size: Specifies the allowed size of each log file.
logfile-size: Allowed size of each log file, in the range 1 to 10 (Mbytes).
directory: Directory under which to save a log file.
1-11
Chapter 1 Information Center