HP Indigo press 3050 User Manual page 88

The lubrication points are described in sequence by press side: front, right (paper feed),
left (paper exit), and rear sections (see Figure 7-1).
Figure 7-1. Press sides
The following symbols are used in Figure 7-2 through Figure 7-21 to indicate the required
lubricant:
O — indicates the place at which oil is to be applied
G — indicates the place at which grease is to be applied
Use the following lubricating oils and greases:
Note Do not over-apply lubricants. A number of lubrication points are protected by spring-bearings.
To lubricate these points you must apply pressure on the bearing, and then apply oil. For best
results, use an oil can with a long spout.
ENWW
Paper exit
Front
Input conveyor
grease, mechanic (lubrication grease)
gear oil, sep 32 or equivalent (lubrication oil)
grease BG-87 Molykote or equivalent (for main drum gear lubrication only: PIP, ITM,
and impression drums)
Rear
Paper feed
Mechanical system lubrication 87