Adjusting The Input Tray; Before You Begin - HP Indigo press 3050 User Manual

3
Stack height adjustment
knob
Side guide lock
handle
Figure 11-16. Input paper secondary tray
4
5
6
7
8
9
10 If necessary, fan the stack again.
11 Adjust the input tray.

Adjusting the input tray

Adjust the transport system to ensure smooth feeding and ejection of the substrate. You
should adjust the substrate transport system whenever you load a substrate of a different
weight or size.

Before you begin

Checking sheet separators
1
ENWW
Lift the side guide lock handle to release the side guide.
Paper guide frame
Adjust the position of the side guide. Look at the side guide position ruler on the main
tray and adjust the secondary tray side guide to the same positions.
Raise the paper guide frame and the trailing edge blower bar.
Pick up a stack of sheets in both hands. Twist and fan the paper to separate and air
the sheets.
Place the stack carefully on the tray. Align the edges until the entire stack is straight.
Push the stack forward against the leading edge guides.
Align the stack horizontally and vertically.
Place the stack exactly in the middle of the tray between the side guides. The
distance from either the wall, rear, or front to the sheet margin must be equal.
Verify that all sheet separator blades are at the same height to a ±1 mm (±0.04 inch)
tolerance. If the sheet separators do not meet this specification, replace them. See
'Replacing the sheet separators on the Paper Feed Unit' on page 181.
Trailing edge paper
guide
Trailing edge
blower
Trailing edge
blower valve
Vacuum valve
Leading edge and
side blowers valve
Adjusting the input tray 161