HP Indigo press 3050 User Manual page 146

16 After the jig is in place, push the sleeves on either side of the jig outward, and lock
Figure 10-17. Jig latches
Figure 10-18. PIP underlayer installation
Note Two persons will be required for this procedure.
17 To mount the PIP underlayer on the PIP drum:
Note Verify that the PIP underlayer is not skewed and is centered between the PIP drum shoulders.
ENWW
them in place with the latches on the outside walls.
a One person should hold the PIP underlayer with the mounting strip facing toward
him and the transparent protective coating (see white tab) facing up (Figure
10-18).
b He should then insert the PIP underlayer mounting strip entirely in the PIP holder
slit, including the metal retaining strip.
c A second person should rotate the handwheel counterclockwise until the roll has
completely wrapped around the drum.
• The roll should pass between the jig and the PIP drum.
• Make sure that the strip is inserted completely along the width of the PIP
underlayer.
Mounting tab
White strip attached
to mylar side
PIP underlayer
Latch for jig
sleeves
Jig sleeve
Replacing the PIP 145