HP Indigo press 3050 User Manual page 147

PIP drum
PIP groove
PIP underlayer
installation jig
Layer roll with
transparent
protective coating
(mylar) on top
Figure 10-19. Mounting the PIP underlayer
PIP drum
PIP underlayer
installation jig
PIP underlayer
top without
transparent
protective coating
Figure 10-20. Installing the PIP underlayer
146 Chapter 10 PIP
d Rotate the drum clockwise and at the same time unrolling the PIP underlayer until
the PIP holder slit is above the jig surface.
e Fold the PIP underlayer sheet between the metal and plastic of the mounting strip
over the jig and set the sheet edge parallel to the jig surface.
f Make sure that the jig just touches the PIP underlayer.
g Peel the protective coating straight, starting at the jig top edge to about 10 cm
from the end.
h One person should hold the PIP underlayer unrolled straight.
i A second person should rotate the handwheel very slowly clockwise to apply the
PIP underlayer to the entire drum surface.
• The layer should pass between the drum surface and the jig.
• Turn the drum one complete rotation.
ENWW