Table of Contents
Advertisement
9
Figure 9-6. Lift the leading edge with the needlenose pliers
10 Using the needlenose pliers, lift up the metal fastener bar.
WARNING!
The bar is extremely hot and can cause injury.
11 Press the Inching button to advance the machine slowly. Continue peeling off the
12 Use the following procedure to remove the adhesive residue from the ITM:
Figure 9-7. Clean the ITM drum
ENWW
Gently pull the leading edge of the blanket.
BLANKET REMOVAL2A1
blanket.
a
Roll the old blanket so that the adhesive side faces out. Press an
Emergency Stop button.
b
Press the sticky side of the blanket to the bare ITM to pick up adhesive residue.
c
Clean the ITM drum surface that is accessible.
d
Release the Emergency Stop button. Press the Inching button to advance the
drum until a new section of the drum is accessible.
e
Repeat this procedure until the ITM drum is free of adhesive residue. See
'Inch-safe-service method' on page 32
.
Old blanket
adhesive side up
Replacing the blanket 117
Advertisement
Table of Contents
Troubleshooting
